Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Estoril 88
#1
Estoril 88

nogrip

:1a:

[Image: screen9355.jpg]

Estoril 1988 was build for rF "from the scratch" by Carrera4.
based on the convertion to GTL by derDumeklemmer
with the permission of Carrera4.

:push::laugh::fixe::racer:
If you want finish in first, first you need to finish.

CManzini - ABRacing #19 Driver
[Image: ?u=Cizot&u3=8555786]
Reply
#2
So uma pergunta Christian, se fui eu quem pôs este post aqui ontem à noite, pq mudou para o teu user? Postei em algum sítio errado? Tenho ideia inclusive de o ter posto correctamente na zona das Pistas, hoje vinha cá ver se havia pessoal q já tinha comentado algo ou andado nela e aparece mudado e com o teu nome...estranho...
[Image: mclarensj5.jpg]
Reply
#3
Joao, nao sei..eu tinha postado a uns dias atras...ask administraçao!!!:blink1:
If you want finish in first, first you need to finish.

CManzini - ABRacing #19 Driver
[Image: ?u=Cizot&u3=8555786]
Reply
#4
O Christian tinha postado 1º mas na secção errada...e assim foi feito o merge dos 2 posts e agr na secção correcta.
Como o Christian tinha o post mais cedo...ficou ele como criador do tópico. ;)
"A primeira lei da natureza é a tolerância - já que temos todos uma porção de erros e fraquezas."
GhostSpeed.net
rFactor 3d Scenes!
Reply
#5
lol, entao fica assim eu como criador e o Joao com o design.:fixe::biggrinbandit:
If you want finish in first, first you need to finish.

CManzini - ABRacing #19 Driver
[Image: ?u=Cizot&u3=8555786]
Reply
#6
so atualizando...

AIW fixed up for rolling start.

nogrip
If you want finish in first, first you need to finish.

CManzini - ABRacing #19 Driver
[Image: ?u=Cizot&u3=8555786]
Reply
#7
O ficheiro não está disponível, há algum outro lado onde se possa arranjar?
Reply
#8
Se a pista for em gelo como no rfactor esquecam.. :( é pena
Reply
#9
ArraySe a pista for em gelo como no rfactor esquecam.. :( é pena[/quote]


Gelo? Que gelo?

Só se fôr às 7 da matina por estas alturas :biggrinbandit::biggrinbandit:

Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)